Taskconf.ini - Siemens SINUMERIK 840D sl Commissioning Manual

08/2005
[151.1]
tool_type=151
width=
;TC_DPV3=
;TC_DPV4=
;TC_DPV5=
; data set for tool_types 200-299
[200.001]
tool_type=
tip_angle=
;TC_DPV3=
;TC_DPV4=
;TC_DPV5=
; default tool data sets reserved by SIEMENS AG for later use
; default data sets are recognized by non digit values
; examples
;[500]
;insert_length=
;holder_angle=
;reference_direction=
;clearance_angle=
;[510]
;insert_length=
;holder_angle=
;reference_direction=
;clearance_angle=

2.5.24 TASKCONF.INI

[CONTROL]
MDIList=MntMMC\MntMMC.mdi
ControlFile=MntMMC\MntMMC.zus
ScreenTwips=1
[DEBUG]
;MDISize 0 = Debug, 1 = Full screen
MDISize=0
;Buttons: 0 = button invisible, 1 = button visible
Stop_Button=1
; Here you can configure a skeleton application. Instead of APPLICATION, use
; the section name configured in regie.ini. For every section name assigned in regie.ini
; with Task
; a standalone section must be configured here.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
= name:= mntmmc cmdLine:= "SectionName", ...
i
Commissioning HMI Advanced (IM4)
2 Functions/Parameterization
; unique identifier (t,d) for saw
; tool type, if not set, $TC_DP1 is
; used
; TC_DP9, width
; 1=+X; -1=-X
; 1=+Y; -1=-Y
; 1=+Z; -1=-Z
; unique identifier (t,d)
; tool type, if not set, $TC_DP1 is
; used
; TC_DP24, tip angle
; 1=+X; -1=-X
; 1=+Y; -1=-Y
; 1=+Z; -1=-Z
; number corresponding to tool type, roughing tool
; TC_DP8, insert length
; TC_DP10, holder angle
; TC_DP11, cutting direction
;TC_DP24, clearance angle
; number corresponding to tool type, finishing tool
; TC_DP8, insert length
; TC_DP10, holder angle
; TC_DP11, cutting direction
; TC_DP24, clearance angle
IM4/2-117