Siemens SINUMERIK 840D sl Commissioning Manual page 419

08/2005
Response in M:N (SINUMERIK powerline only)
In the M:N function the two text lines must be cleared in passive switching. In
active switching, as in area switching, the content of the variables is evaluated and
displayed.
Task
The following texts should be output in the "Program name" field in the header of
JOG and MDA modes:
• "Handwheel acting on axis ..." in the first line with the appropriate axis name
• "Slide ... active" in the second line with the appropriate slide number.
Procedure
1. Identify the PLC-HMI interface in the HEADER.INI file, e.g., DB60.DBB10
2. Enter the name of the PLC user text file in MBDDE.INI,
e.g.
[TextFiles]
UserPLC=alpu
3. Enter texts in the PLC user text file,
e.g.
700100
700101
4. Initiate text display from the PLC and describe the interface, e.g., for the first
display line:
DB60.DBW11 = 100
DB60.DBB14 = 2
DB60.DBB10 = 1
e.g., for the second display line:
DB60.DBW31 = 101
DB60.DBB33 = 1
DB60.DBB30 = 1
Result
With the following axis configuration:
MD 20080 AXCONF_CHANAX_NAME_TAB[0] = "X"
MD 20080 AXCONF_CHANAX_NAME_TAB[1] = "Y"
MD 20080 AXCONF_CHANAX_NAME_TAB[2] = "Z"
the display is as follows:
"Handwheel acting on Y axis" (first display line)
"Slide 1 active"
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
0 0 "Handwheel acting on axis %2"
0 0 "Slide %1 active"
(second display line)
Commissioning HMI Advanced (IM4)
2 Setting Functions and Parameters
IM4/2-25