Communication/Initial Requirements; Internal System Communication - Siemens SINUMERIK 840D sl Commissioning Manual

Starting Up HMI Embedded (IM2)

3 Communication/Initial Requirements

3.1 Internal system communication

Internal system communication in the NCU between the HMI Embedded software,
NCK, drive, and PLC is carried out via an integrated PROFIBUS DP (VDP).
For a description, please refer to the following documentation:
References: /IDsl/ Installation and Startup Manual CNC Part 1 (NCK, PLC, Drive)
3.2 Licensing
A suitable license is needed in order to use the options.
In the "Startup" operating area, HMI Embedded has three menus, which contain
information about the status of the options and their licenses.
Requirements
You need at least "write access" authorization in order to set or reset options.
Procedure
To call up the following three menus in the "Startup" operating area, select the ETC
key ">" and press the "License" softkey:
• Overview
• All options
• Missing licenses
Licensing: overview
The following information appears when you press the "Overview" softkey:
Hardware serial number:
Type of hardware, e.g.:
Status message of the license key, e.g., "License key is NOT sufficient!"
When you obtain a new license key, it must be entered after the prompt "Please
enter a license key:".
Hyphens are inserted automatically after every fourth character for increased
legibility.
When you press the "Apply" softkey, the data are transmitted to the NCU and
stored there.
The licenses are not effective until you press the "NCK Reset" softkey.
IM2/3-16
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
Shows the unique number of the Sinumerik sl
Sinumerik 840D sl
© Siemens AG, 2005. All rights reserved
08/2005