Siemens SINAMICS G120 Operating Instructions Manual page 6

Changes in this manual
New functions in firmware V4.7 SP3
Fast flying restart for PM330 Power Modules:
The "Flying restart" function does not have to wait for the
motor demagnetization time, and identifies the motor speed
without requiring a search operation.
New or revised default settings of the interfaces: p0015
macros 110, 112 and 120
Communication expansion via Modbus:
Adjustable parity bit, access to parameters and analog in-
puts
Extending communication via BACnet:
Access to parameters and analog inputs
The bus error LED for communication via USS and Modbus
can be switched off
You can find an overview of all new and modified functions in firmware V4.7 SP3 in Section
New and extended functions (Page 431).
Corrections
Minimum operating temperature: -10 °C (and not 0 °C)
Revised descriptions
Terminal strips, factory setting and default settings of the
terminal strips
Startdrive commissioning tool added
Manual speed control optimization
6
In Chapter
Setting is not required for the user
Default setting of the interfaces
(Page 88)
See "Fieldbuses" Function Manual,
Manuals for the Control Unit
(http://support.automation.siemens.co
m/WW/view/en/30563628/133300)
See "Fieldbuses" Function Manual,
Manuals for the Control Unit
(http://support.automation.siemens.co
m/WW/view/en/30563628/133300)
Operating states indicated on LEDs
(Page 348)
In Chapter
Technical data for CU230P-2
(Page 369)
In Chapter
Terminal strips (Page 84)
Commissioning with a PC (Page 135)
Optimizing the speed controller
(Page 229)
Converter with CU230P-2 Control Units
Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB