Ethernet/Ip - Siemens SINAMICS G120 Operating Instructions Manual
Low voltage converters, chassis and wall/panel mounted devices with cu230p-2 control units
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
6.2.11.5
Ethernet/IP
Settings for Modbus RTU
Parameter
p2030 = 10
p8920
p8921
p8922
p8923
p8924
p8925
p8980
p8982
Further information
You can find additional information about USS in the "Fieldbuses" Function Manual: Manuals
for the Control Unit (http://support.automation.siemens.com/WW/view/en/30563628/133300).
Converter with CU230P-2 Control Units
Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB
Explanation
Fieldbus interface protocol selection: Ethernet/IP
PN Name of Station
PN IP address (Factory setting: 0)
PN default gateway (factory setting: 0)
PN Subnet Mask (Factory setting: 0)
PN DHCP mode (Factory
setting: 0)
PN interface configuration
(Factory setting: 0)
Ethernet/IP profile (Factory setting: 0)
A change only becomes effective after the inverter power
supply has been switched off and switched on again.
Ethernet/IP ODVA speed scaling (Factory setting: 128)
A change only becomes effective after the inverter power supply has been switched
off and switched on again.
123: 32
124: 16
125: 8
126: 4
0: DHCP off
2: DHCP on, identification based on MAC address
3: DHCP on, identification based on Name of Station
0: No function
1: Reserved
2: Save the configuration and activate
3: Delete configuration
127: 2
128: 1
129: 0.5
130: 0.25
Advanced commissioning
6.2 Inverter control
0: SINAMICS
1: ODVA AC/DC
131: 0.125
132: 0.0625
133: 0.03125
199
Advertisement
Table of Contents
