Siemens SINAMICS G120 Operating Instructions Manual page 280

Advanced commissioning
6.7 Application-specific functions
Settings
Parameters
p2165
p2168
p2181
p2182
p2183
p2184
p2186
p2188
p2190
p2191
p2192
p2193 = 3
Table 6- 40
p2181 = 0
p2181 = 1
p2181 = 2
p2181 = 3
p2181 = 4
p2181 = 5
p2181 = 6
p2181 = 7
p2181 = 8
The settings in p2193 for pumps/fans (p2193 = 4 or 5) are only permissible with the settings
for load monitoring for pumps/fans (p2181 = 7 or 8)
280
Description
Load monitoring blocking monitoring threshold, upper
Load monitoring blocking monitoring torque threshold
Load monitoring response
Response when evaluating the load monitoring. Setting options, see Table 6-40
Response options for load monitoring (Page 280)
Load monitoring speed threshold 1
Load monitoring speed threshold 2
Load monitoring speed threshold 3
Load monitoring torque threshold 1, lower
Load monitoring torque threshold 2, lower
Load monitoring torque threshold 3, lower
Load monitoring torque threshold, no load
Load monitoring delay time
Load monitoring configuration
see Table 6-39 Setting options for load monitoring (Page 276)
Response options for load monitoring
Load monitoring deactivated (factory setting)
A07920 for torque/speed too low
A07921 for torque/speed too high
A07922 for torque/speed out of tolerance
F07923 for torque/speed too low
F07924 for torque/speed too high
F07925 for torque/speed out of tolerance
Pump/fan load monitoring as alarm
Pump/fan load monitoring as fault
Converter with CU230P-2 Control Units
Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB