Siemens SINAMICS G120 Operating Instructions Manual page 315

Low voltage converters, chassis and wall/panel mounted devices with cu230p-2 control units

Hide thumbs Also See for SINAMICS G120:

Table of Contents

Manually transferring

Preconditions

• The inverter power supply has been switched on.

• No memory card is inserted in the inverter.

Procedure with STARTER

Proceed as follows to transfer settings from a memory card to the inverter:

1. Go online and in your drive, select the "Drive Navigator".

2. Select the "Commissioning" button.

3. Select the button to transfer the data from the memory card to the inverter.

4. Select the settings as shown in the diagram and start the data backup.

5. Wait until STARTER signals that the data backup has been completed.

Converter with CU230P-2 Control Units

Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB

Backing up data and series commissioning

7.1 Backing up and transferring settings using a memory card

Sinamics g120c Sinamics g120p