Siemens SINAMICS G120 Operating Instructions Manual page 450
Low voltage converters, chassis and wall/panel mounted devices with cu230p-2 control units
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
Appendix
A.5 Interconnecting signals in the converter
Explanation of the example using the ON/OFF1 command
Parameter p0840[0] is the input of the "ON/OFF1" block of the inverter. Parameter r20031 is
the output of the AND block. To interconnect ON/OFF1 with the output of the AND block, set
p0840 = 20031.
Figure A-8
Principle for interconnecting blocks
Always interconnect the input (connector or binector input) with the signal source.
450
Interconnecting blocks by setting p0840[0] = 20031
Converter with CU230P-2 Control Units
Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB
Advertisement
Table of Contents
