Siemens SINAMICS G120 Operating Instructions Manual page 57
Low voltage converters, chassis and wall/panel mounted devices with cu230p-2 control units
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
Procedure
Proceed as follows to correctly install the Power Module:
1. Prepare the cutout and the mounting holes for the Power
Module and the mounting frame corresponding to the
dimension drawings of the mounting frame.
Also note that the PT Power Modules must be vertically
mounted with the line and motor connections facing
downwards.
2. Position the mounting frame at the rear of the control
cabinet and attach it to the control cabinet by tightening
the corresponding screws by hand.
3. Attach the seal to the inner side of the control cabinet.
4. Fix the inverter, and first tighten all of the fixing screws
by hand.
5. Tighten the screws with a torque of 3.5 Nm.
You have correctly installed the Power Module.
Converter with CU230P-2 Control Units
Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB
Installing
4.4 Installing Power Modules
Mounting frame
57
Advertisement
Table of Contents
