ANSI Hardware Installation Manual
Figure 50
6
Issue: 09
Inserting the cable connector into a VL port on the NDPS-B card
VL cable
Route the VL cable through the appropriate cable exit area of the shelf; see Figure
cable exit areas:
•
for a vertically mounted shelf (cards oriented vertically):
•
for the VL cable to stretch comfortably, it is recommended that the vector processing card
be installed in slot #9
•
for a VL cable connected to ports VL1 though VL4 on the NDPS-B card, route the cable
straight up through the cable exit area above the NDPS-B card
•
for a VL cable connected to ports VL5 though VL8 on the NDPS-B card, route the cable
up and then towards the PWIO-B card so that the VL cable exists the shelf above PWIO-
B card
•
for a horizontally mounted shelf (cards oriented horizontally):
•
for the VL cable to stretch comfortably, it is recommended that the vector processing card
be installed in slot #9
•
for a VL cable connected to ports VL1 though VL4 on the NDPS-B card, route the cable
straight to left through the cable exit area to the left of the VIPR-B card
•
for a VL cable connected to ports VL5 though VL8 on the NDPS-B card, route the cable
towards the left and then up towards the PWIO-B card so that the VL cable exists the
shelf at the left side of the PWIO-B card
3HH-12893-AAAA-TCZZA
VL port
VL1
DRAFT
7360 ISAM FX-16 shelf cabling
VL2
23722
51
for VL
123