Fiber Cables; Fiber Management Guides; Routing Fiber Optic Cables - Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual

ANSI Hardware Installation Manual
12.2.3
Standard single-mode fiber cables with LC connectors are connected to the SFP
optical modules for transmit (Tx) and receive (Rx) purposes.
The GPON and EPON SFPs require an SC/UPC connector.
The NELT-B requires 90° fiber connector strain relief boots.
12.2.4
Fiber management guides are recommended for installation on 7360 ISAM FX-12
shelves, in order to provide proper fiber optic cable handling. Fiber management
guides are used for:
•
•
One fiber management guiding element is required for every three LT cards, and for
the two NT cards and one NTIO card.

12.3 Routing fiber optic cables

This section provides procedures for mounting fiber management guides, routing
and connecting fiber optic cables to the NT and LT cards for 7360 ISAM FX-12, and
for installing optical modules.
Figure
Issue: 09
For an overview of the supported SFP modules, see
Note 1 —
the 7360 ISAM FX Product Information Guide.
Nokia recommends protecting any SFP cage that is
Note 2 —
not equipped with an SFP module, with a dust cover in order to
prevent dust intrusion.
The type of optical fibers selected must match the
Note 3 —
particular SFP to guarantee the overall optical budget in the
system and it's correct operation. Loss of optical power as a
result of a mismatch in materials must be avoided.

Fiber cables

Fiber management guides

fiber management for the NT and NTIO cards
fiber management for the LT cards
111 shows the mounting of the 7360 ISAM FX-12 fiber management guide.
3HH-12893-AAAA-TCZZA
Fiber optic cable management in the 7360 ISAM
DRAFT
FX-12 shelf
215