ANSI Hardware Installation Manual
6
7
8
Procedure 84
Depending on the configuration, the 7360 ISAM FX-4 can house up to 4 line termination (LT)
cards.
Figure
Issue: 09
Wait until the NT card in the NT-A slot is fully operational. The card first displays a heartbeat
signal, that is, the green PWR LED is flashing. Then the card displays an enabling operation
signal, that is:
•
the green PWR LED is steady on
•
the green A/S LED is steady on
•
the red ALM LED is off
Install the second NT card in slot NT-B in the same way, then install the NT dummy panels
in any unused, unpopulated NT card slot to maintain proper operation.
STOP. This procedure is complete.
To install LT cards
218
shows the LT card slots.
3HH-12893-AAAA-TCZZA
Installing cards in the 7360 ISAM FX-4 shelf
DRAFT
377