Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual page 219

ANSI Hardware Installation Manual
6
7
8
Procedure 47
To install optical modules, proceed as follows:
1
2
3
Issue: 09
Insert the fiber cables into the appropriate optical modules located on the front panels of the
NT and LT cards. If optical modules must first be installed, see Procedure 47.
Route and connect the other end of the fiber cables as per site practices.
STOP. This procedure is complete.
Installing an optical module
Caution — It is important to install optical modules prior to connecting
power to a 7360 ISAM FX shelf.
Put on an antistatic wrist strap and connect it to a grounding point.
Install an optical module as follows:
i Align the optical module with an optical module port and slide it into the port until it clicks
into place.
ii Remove the rubber cap from the optical module.
Note — The optical module can only be removed when the pull-down
bar is released.
STOP. This procedure is complete.
3HH-12893-AAAA-TCZZA
Fiber optic cable management in the 7360 ISAM
DRAFT
FX-12 shelf
219