7360 Isam Wm Power Cable; Table 17 Supported 7360 Isam Wm Power Cable - Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual

ANSI Hardware Installation Manual
22.5.1.1
Power cables are routed from the power interface of the 7360 ISAM WM power card
to the power terminals of either the 7360 ISAM FX-16, 7360 ISAM FX-8, or
7360 ISAM FX-4, through the left side of the rack. See Table
power cable, and see Figure
Table 17 Supported 7360 ISAM WM power cable
Part number
3FE 72530 AA
Figure 237

7360 ISAM WM power cable

R
B
A
22.5.1.2
The power cable is routed from the FWPC-A at the front of the 7360 ISAM WM,
through the left side of the rack, and connected to the power terminals at the bottom
of the 7360 ISAM FX-16 shelf. See Figure
the 7360 ISAM FX-16, and see Figure
7360 ISAM WM shelf the FX-16 shelf.
Issue: 09
Power cable
Connection point for 3-pin, D-
SUB connector
FWPC-A power interface PW1.
PW2 is used for power redundancy
(using two 7360 ISAM FX-16
shelves, though this function is not
yet supported).
Power cable routing and connection
The 7360 ISAM WM can also be installed in a rack with
Note —
a 7360 ISAM FX-8 or 7360 ISAM FX-4 shelf, with similar
cabling procedures. Contact your Nokia representative for
more information.
3HH-12893-AAAA-TCZZA
237 for a view of the supported power cable.
Connection point for 8 mm
lug
BAT-A, BAT-B, and
BATRET-A/B on
7360 ISAM FX-16,
7360 ISAM FX-8, or
7360 ISAM FX-4 shelves.
238 for the location of power terminals on
239 for the cabling routing from the
DRAFT
7360 ISAM WM shelf cabling
17 for the supported
Maximum Maximum
current length
15 A 2 m
25784
411