Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual page 429

ANSI Hardware Installation Manual
Procedure 99
Use the following procedure to remove a cards.
1
2
3
4
5
6
Issue: 09
To remove cards
Put on the antistatic wrist strap and connect it to the earth bonding point at the bottom of the
7360 ISAM WM shelf; see Figure 249.
Test the ESD wrist strap with the ohmmeter to ensure effectiveness; it must measure 1 MΩ
+/-20% to ground.
Loosen the fixation screws located at the top and bottom of the front panel of the card.
Use the ejector handles to disengage the card connectors from the backplane. Figure
shows the ejector handles for 7360 ISAM WM cards.
Remove the card from its slot and place it in an ESD protective bag.
STOP. This procedure is complete.
3HH-12893-AAAA-TCZZA
Installing cards in the 7360 ISAM WM shelf
DRAFT
251
429