Installing cards in the 7360 ISAM FX-12 shelf
Figure 105
5
6
Procedure 44
Use the following procedure to change the NGFC-I card on the 7360 ISAM FX-12 shelf.
1
2
208
Ejector handles for NT cards
Remove the card from its slot and place it in an ESD protective bag.
STOP. This procedure is complete.
To change the NGFC-I card
Before disconnecting the power cable, ensure that power to the cables has been
disconnected and the circuit breakers are switched to the off position.
Warning — If the following steps to disconnect the power cables are
not followed exactly, there can be a possible fire hazard.
Remove the safety cover and power cable connectors (loosen and remove the screws); see
Figure 106.
3HH-12893-AAAA-TCZZA
ANSI Hardware Installation Manual
33.77 in.
85.8 cm
DRAFT
22375
Issue: 09