Table of Contents
Advertisement
3
Connecting to Ethernet Ports
Caution
Cables that connect to Ethernet ports must be IEEE 802.3 compliant to prevent
potential data loss.
To connect to a 10-Mbps, 100-Mbps, or 1000-Mbps hub, use a straight-through RJ-45 cable.
To connect directly to a host, use an RJ-45 crossover cable.
Use IEEE 802.3 10/100 BASE-TX, 1000 BASE-T CAT 5 unshielded twisted-pair, full-duplex or
half-duplex cable.
You can order appropriate adapter cables separately. You can order additional cables from a
cable vendor of your choice.
The following figure shows the pin assignments for the cable. The RJ-45 cable output connector
is numbered from left to right, with the copper tabs facing down and toward you.
Figure 8 Output Connector for the Ethernet Cable
28
00270.1a
1
8
Pin#
Assignment
1
TX
2
TX
3
RX
4
5
6
RX
7
8
Nokia IP150 Security Platform Installation Guide
Advertisement
Table of Contents
