Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual page 295

ANSI Hardware Installation Manual
5
6
7
8
Procedure 63
Depending on the configuration, the 7360 ISAM FX-8 can house up to 8 line termination (LT)
cards.
Figure
Issue: 09
Press the insertion/extraction tabs on the front panel to lock the card in place. Attach fixation
screws located at the top and the bottom of the front panel of the card; see Figure 159.
Maximum torque: 2.66 lbf-in. (0.3 N.m).
Wait until the NT card in the NT-A slot is fully operational. The card first displays a heartbeat
signal, that is, the green PWR LED is flashing. Then the card displays an enabling operation
signal, that is:
•
the green PWR LED is steady on
•
the green A/S LED is steady on
•
the red ALM LED is off
Install the second NT card in slot NT-B in the same way, then install the NT dummy panels
in any unused, unpopulated NT card slot to maintain proper operation.
STOP. This procedure is complete.
To install LT cards
160 shows the LT card slots.
3HH-12893-AAAA-TCZZA
Installing cards in the 7360 ISAM FX-8 shelf
DRAFT
295