Figure 219 Ejector Handles For Lt Cards - Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual

ANSI Hardware Installation Manual
8
9
Procedure 85
Use the following procedure to remove cards.
1
2
3
4
Figure 219
Issue: 09
Install LT card dummy panels in any unused, unpopulated LT card slots to maintain proper
operation.
STOP. This procedure is complete.
To remove cards
Put on the antistatic wrist strap and connect it to the earth bonding point at the bottom of the
7360 ISAM FX-4; see Figure 214.
Test the ESD wrist strap with the ohmmeter to ensure effectiveness; it must measure 1 MΩ
+/-20% to ground.
Loosen the fixation screws located at the top and bottom of the front panel of the card.
Use the ejector handles to disengage the card connectors from the backplane. Figures
and 220 show the ejector handles for LT cards. Figure
cards.
Ejector handles for LT cards
3HH-12893-AAAA-TCZZA
Installing cards in the 7360 ISAM FX-4 shelf
Withdrawl
DRAFT
221 shows the ejector handles for NT
Guiding plate
22376
219
379