Installing A Replacement Hard Disk (Sw 4.4 And Higher) - Siemens SINUMERIK FM-NC Installation And Startup Manual

11 Data Backup

11.6 Installing a replacement hard disk (SW 4.4 and higher)

11.6 Installing a replacement hard disk (SW 4.4 and higher)
MMC 103
R
Norton Ghost
Note
Restoring a
backup
É É É É
É É É É
É É É É
11-274
The following section describes how to restore a data backup of a complete
MMC 103 hard disk for the purpose of having all user and system data continu-
ally available during servicing.
R
The "Norton Ghost " software allows the complete contents of an MMC102/103
hard disk to be saved as a "disk image file". This disk image file can be stored
on various types of data medium for the purpose of restoring the hard disk at a
later time.
R
The Norton Ghost program is supplied as standard with every MMC103
module and the replacement hard disk.
For further information, please visit the Internet site at "www.ghost.com" or refer
to the previous section.
Recommendation:
We recommend you archive the hard disk image backup and the "Norton
Ghost" program on CD.
Requirements:
S
The Ghost program is installed on the programming device.
S
A new replacement hard disk is installed.
S
The MMC103 is connected to the PC/PG via a parallel cable
S
One of the operating systems Windows 3.x or Windows 95 and a CD–ROM
drive are installed on the programming device.
LPT1:
(X8)
MMC 102/103
1. Install the new replacement hard disk in the MMC 103 or install a new MMC
(see enclosed instructions)
– Slot the hard disk into the bracket
– Connect the cable between the hard disk and the MMC
– Fix the hard disk in place with the 4 knurled screws
– Release the transport safeguard: turn towards "operating" until it clicks
into place.
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
À À À À
LPT:
À À À À
À À À À
PG/PC
 Siemens AG 2000 All Rights Reserved
12.98
03.96
CD