Siemens SINUMERIK FM-NC Installation And Startup Manual page 295

12.98
03.96
Tool: SINUCOPY
The SINUCOPY program can be used to:
S
S
Operation
The functions of the program can be called up from the menu bar or by activat-
ing buttons in the user interface. Help is available for all actions by activating the
"Help" menu.
Note
NC data can be written to the NC card (SW 5.1 and later); Operator inputs see:
/BA/ 840D Operator's Guide, Services operating area.
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
Read, write or duplicate the SINUMERIK system software (NC) on NC cards
of the NCU installed on a PC with an active PCMCIA slot. The version identi-
fiers of the programs can be displayed (corresponding to the version display
of the SINUMERIK control).
Read and write the SINUMERIK system software (MMC) on PC cards of the
MMC 100.2.
12 Software and Hardware Replacement
12.4 Upgrading the NC
12
12-295