System Requirements; Installation - Siemens SINUMERIK FM-NC Installation And Startup Manual

03.96
10.1.1

System requirements

Hardware
To be able to use the start-up tool, version 3.1 and higher, the following hard-
ware conditions must be fulfilled:
requirements
S
S
S
S
S
S
S
S
S
Software
Software configuration for start-up tool, software version V 3.1x and higher
requirements
S
S
10.1.2

Installation

Read.me
Please observe the contents of the Read Me file supplied.
To install the software, please follow the procedure detailed below:
Requirement
The memory area of the MPI card must be excluded from use by memory man-
agers (files: CONFIG.SYS, SYSTEM.INI).
Execution
Insert the first floppy disk and start the SETUP.BAT file by means of the WIN-
DOWS
Enter the interface parameter node ID and baudrate (depending on interface
used) in file S7CFGPGX.DAT in the MPI driver directory using an ASCII editor.
Input for interface:
Operator inputs
The installation program requests all further necessary inputs and floppy disk
changes in user dialog.
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
r
IBM AT-compatible PG/PC with DX486 microprocessor,
e.g. SIMATIC PG 740
At least 4 MB of main memory (ideally 8 MB)
Floppy disk drive (3 1/2" or 5 1/4")
Hard disk drive for managing data
Monochrome or color monitor (VGA)
Keyboard
MPI interface
Mouse
Connecting cable to link PG/PC and NCU module
r
Operating system MS–DOS
T
WINDOWS operator interface, software version 3.1 and higher
T
file manager.
X101: 3 (81.5 Mbaud)
10 Drive Optimization with Start-Up Tool
10.1 Instructions for use
version 3.1 and higher
10
10-205