Powering on the system
Power on the system.
Parameter setting
Set the parameters on the master/local module.
Write the parameter settings to the CPU module.
Reset the CPU module or power off and on the system.
When data link is performed normally, the L RUN LED is turned on,
and the ERR. LED is turned off.
Create a control program.
Write the program to the CPU module. Reset the CPU module or power
off and on the system.
*1
The parameters can be set using dedicated instructions. (
58
Checking operation
with the LED display
Programming
*1
Page 205, Section 9.8)
Page 93, CHAPTER 7
Page 228, CHAPTER 10