Automatic Cc-Link Startup - Mitsubishi Electric MELSEC-Q Series User Manual

8.3.3

Automatic CC-Link startup

Data link can be performed with the default settings by powering on the master/local module. This function is used to
check the operation of when a system is configured.
This function can be also used in a system containing a remote I/O station as well as a remote device station and
intelligent device station.
Master station
(1) Default parameter settings when CC-Link is automatically started up with a
master/local module operating as a master station
When a master/local module is started up with the station number 0, it is started up as a master station.
The table below lists the parameter settings of when CC-Link is automatically started up by a master/local module
operating as a master station.
Operation Setting
Mode
Total Module Connected
Refresh devices
Retry Count
Automatic Reconnection Station Count
Standby Master Station No.
PLC Down Select
Scan Mode Setting
Delay Time Setting
Station Information Setting
(a) Operation Setting
Data Link Faulty Station Setting
Case of CPU STOP Setting
Block Data Assurance per Station
Remote I/O station
Item
Refer to Page 159, Section 8.3.3 (1) (a).
Remote Net (Ver.1 Mode)
64
Refer to Page 160, Section 8.3.3 (1) (b).
3
1
No setting
Stop (When an error occurs in the CPU module of a master station, data link
stops.)
Asynchronous
0
Refer to Page 160, Section 8.3.3 (1) (c).
Item
Clear the input data.
Refresh.
Disable the setting.
Remote device station Intelligent
device station
Setting details
Setting details
CHAPTER 8 FUNCTIONS
159
8