Mitsubishi Electric MELSEC-Q Series User Manual page 106

[Select modules in "Module List" and drag and drop them to "List of stations"]
1.
Open the CC-Link configuration window.
Project window
button
2.
Select modules in "Module List" and drag and drop them to "List of stations".
Slave stations are added to "List of stations". The added modules are displayed in the device map area as
well.
3.
When completing the setting, close the CC-Link configuration window.
[CC-Link Configuration]
List of stations
Device map
area
Item
Select the mode of a master station. (
Mode Setting
Page 55, Section 3.6.6)
Select the transmission speed of a master station.
Note that this setting is used only to display "Link Scan Time
(Approx.)". For the transmission speed of a master/local module, set it
TX Speed
with a transmission speed/mode setting switch on the module. (
Page 21, CHAPTER 2)
The estimate value of link scan time is displayed.
Link Scan Time
For the estimate value of link scan time, refer to following.
(Approx.)
(
• For a master station
• For a slave station
Station No.
The model name of the module is displayed.
Model Name If the module information cannot be found, "Module without profile" is
displayed.
104
[Parameter]
[Close with Reflecting the Setting]
Drag and drop the text.
Description
Page 366, Appendix 4.1)
0/0 is displayed.
The order of the slave station is displayed before the slash.
The start station number of the slave station is displayed after the
slash.
[Network Parameter] [CC-Link]
Page 43, Section 3.6.2 to
Setting range
• Ver.1 Mode
• Ver.2 Mode
• Addition Mode
• Remote I/O Mode
(Default: Ver.1 Mode)
• 156kbps
• 625kbps
• 2.5Mbps
• 5Mbps
• 10Mbps
(Default: 156kbps)
–
–
–