Mitsubishi Electric MELSEC-Q Series User Manual page 252

2
AJ65VBTCU-68DAVN: Initial setting change
AJ65VBTCU-68DAVN: Digital value setting
AJ65VBTCU-68DAVN: Analog output enable/disable setting
AJ65VBTCU-68DAVN: Process at error occurrence
When creating the program
as needed.
The program
2.
Write the program to the CPU module in the master station. Then reset the CPU module or power
off and on the system.
[Online]
250
, refer to the manual for the remote device station used and change the program
1
is needed only for the initial setting change.
2
[Write to PLC]
or power off on
Analog output enable/disable
setting (RWw8)
CH.1 to 4 output range setting
(RWw9)
Turn on Initial data setting
request flag (RY19).
Turn off Initial data setting
request flag (RY19).
Set CH.1 digital value setting
(RWw0).
Set CH.2 digital value setting
(RWw1).
Turn on CH.1 analog output
enable/disable flag (RY00).
Turn on CH.2 analog output
enable/disable flag (RY01).
Read CH.1 check code (RWr0)
and CH.2 check code (RWr1).
Read Error code (RWr8).
Turn on Error reset request
flag (RY1A).
Turn off Error reset request
flag (RY1A).