Figure 31: Fault Recorder - Triggered Recording Configuration Section - GE RPV311 Technical Manual

RPV311
Figure 31: Fault recorder – triggered recording configuration section
RPV311-TM-EN-7
A The E check box allows user to enable the fault recorder feature.
NABLED
B The P text field allows user to enter the recording time before the event in
RE TIME
seconds. The P
OST TIME
event in seconds. The T
seconds, where the event will be recorded. The D
–
TRIGGERS IN THE LAST SECONDS
within a programmed time period.
C The T field contains all the thresholds created. The logic equation uses
RIGGER LOGIC
AND and OR logic operators over previously defined thresholds. Initially, all preset
thresholds are displayed as implicit OR operators, one per line.
To enable thresholds individually, click on the threshold and select E
To disable discarded thresholds individually, click on the threshold and select D
To break or remove complex thresholds, click on the threshold and select C
To create equations with AND operators, follow the procedures below:
 Click on the threshold and select Cut last;
Click on the threshold to which is desired to add the previously selected

threshold and then select the threshold to be added.
D Selecting the R
ECEIVE
check box enables these features. It allows the start of the recording of an
exceeded threshold by Ethernet cross-trigger.
E The R scroll box allows user to select the rate on the fault recorder (64, 128,
ATE
or 256).
text field allows user to enter the recording time after the
text field allows user to enter the maximum time in
IME OUT
allows user to disable recorder if the event repeats
E -
THERNET CROSS TRIGGER
Chapter 4 – Configuration
–
ISABLED FOR MINUTES IF MORE THAN
;
NABLE
or S E
END THERNET CROSS
–
;
ISABLE
;
UT LAST
-
TRIGGER
77