Figure 91: Terminal Name Configuration; Figure 92- Warning Menu - GE RPV311 Technical Manual

Chapter 13 – RPV Manager
1.1.1.4 CONTACTS
1.1.1.5 WARNINGS
Polling Menu
2.2.3
RPV311-TM-EN-7
1. Enter the names for the terminals A and B. As configured on the TW screen
in the RPV311, see below.

Figure 91: Terminal name configuration

1. Finally, enter the name of the transmission line.
The field ID shows the ID of the MODBUS transmission of the fault location. Further
information in 2.3 Automatic TW Faul Location.
This menu configures the contacts to which the RPV can send emails notifications.
On this window the user can view the list of registered contacts, add, edit, or remove
any contact. During the removal of any contact, if any association with any warning,
a confirmation message will be displayed to the user.
On this screen the user can view the list of warnings, add, edit or remove any
warning.
By setting the warning the user can select which contact will receive the alarms.
It is possible to configure which events will make the RPV Manager send warning
email, according to the following settings:

Figure 92- Warning menu

Send email when the RPV311 being monitored have active alarms, when a fault is
found in the COMTRADE files. In case a fault has been identified it is possible to attach
the COMTRADE file of that fault to the email.
In the Polling menu, the user can:

Select software polling to be manual;

Select software polling to be automatic;
RPV311
193