Checking The Connection; Communication Through Network Using The Electrical Ethernet Port - GE RPV311 Technical Manual

RPV311
3.1

Checking the Connection

4 Communication Through Network Using the Electrical
Ethernet Port
RPV311-TM-EN-7
IP address, broadcast and netmask of the RPV311
IP Address
Netmask
Broadcast
Set the local connection as follows:
IP address, broadcast and netmask of the local connection
IP Address
Netmask
Broadcast
If the equipment is not with the default IP settings, see Chapter 5: Operation to see
how to check the current IP address.
After connecting the equipment with the computer, see Chapter 4: Configuration for
details about equipment access.
Note:
Process Bus Ethernet port is used only to receive data of
merging units (Sampled Values measured on monitored
Power System). It is not possible to communicate to this
RPV311 using that Ethernet port for s their purposes.
In order to verify whether the equipment connection is correctly set up, connect a
crossover network cable between the computer and the equipment and, using a
command line terminal, run a ping command to the IP address of the equipment.
Chapter 14 – Communications
192.168.0.199
255.255.255.0
192.168.0.255
192.168.0.190
255.255.255.0
192.168.0.255
210