Honda 2004 Odyssey Service Manual page 1963

Power Door Locks/Factory Keyless/Factory Security
Door/Tailgate Key Cylinder Switch
Test (cont'd)
Tailgate (With Security System)
1. Remove the tailgate trim panel (see page 20-61).
2. Disconnect the 3P connector (A) from the switch (B).
B
A
3. Check for continuity between the terminal in each
switch position according to the table.
Terminal
Position
LOCK
OFF
UNLOCK
4. If the continuity is not as specified, replace the
switch.
22-284 22-284
1 2 3
Door Lock Switch Test
1. Remove the inner door handle (see page 20-7).
2. Remove the two screws (A), then remove the door
lock switch (B).
A
3. Check for continuity between the No. 1 and No. 2
terminals in each switch position.
• There should be no continuity with the door lock
switch in neutral or LOCK.
• There should be continuity with the door lock
switch in UNLOCK.
4. Check for continuity between the No. 2 and No. 3
terminals in each switch position.
• There should be continuity with the door lock
switch in UNLOCK.
• There should be no continuity with the door lock
switch in neutral or LOCK.
5. If the continuity is not as specified, replace the
switch.
B