Honda 2004 Odyssey Service Manual page 2348

'03-04 Models
DTC 61-1x (61-10 to 61-19, 61-1A to 61-1F):
Open in Driver's Seat Belt Buckle Switch
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), then buckle and
unbuckle the driver's seat belt several times.
3. Read the DTC (see page 23-38).
Is DT C 61-1x indicated?
YES Go to step 4.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
4. Turn the ignition switch OFF.
5. Disconnect the driver's seat belt buckle switch 3P
connector (A).
6. Buckle the driver's seat belt.
• Check resistance between the No. 1 and No. 3
terminals of the driver's seat belt buckle switch
3P connector. There should be 0 1
• Check resistance between the No. 1 and No. 2
terminals of the same connector. There should
be an open circuit, or at least 1 M .
Are the resistance readings as specif ied?
YES
NO
A
then clear the DTC.
DRIVER'S SEAT BELT BUCKLE SWITCH
3P CONNECTOR
BLK BLU
Terminal side of male terminals
GRY
BLK
Terminal side of male terminals
Go to step 7.
Replace the driver's seat belt buckle assembly,
.
(cont'd)
23-283