Honda 2004 Odyssey Service Manual page 2352

7. Unbuckle the driver's seat belt.
• Check resistance between the No. 1 and No. 2
terminals of the driver's seat belt buckle switch
3P connector. There should be 0 1
• Check resistance between the No. 1 and No. 3
terminals of the same connector. There should
be an open circuit, or at least 1 M .
DRIVER'S SEAT BELT BUCKLE SWITCH
3P CONNECTOR
BLK
Terminal side of male terminals
BLK
Terminal side of male terminals
Is the resistance as specif ied?
YES Go to step 8.
NO Replace the driver's seat belt buckle assembly,
then clear the DTC.
8. Disconnect the negative cable from the battery.
9. Disconnect both seat belt tensioner 2P connectors
from the side wire harness (A).
.
GRY
BLU
A
10. Disconnect SRS unit connector B (28P) from the
SRS unit, dashboard wire harness connector C
(16P) from the gauge assembly, and the driver's
multiplex control unit from the driver's under-dash
fuse/relay box.
B
(cont'd)
23-287