Honda 2004 Odyssey Service Manual page 2418

'02 Model
SRS indicator stays on when in ''SCS'' menu
method
NOTE:
• If you cannot retrieve DTCs with the HDS using the
SRS menu method, retrieve the flash codes with the
Tester in SCS mode (see page 23-36).
• A new SRS unit must sense the entire system is OK
before completing its initial self-test. The most
common cause of an incomplete self-test is the
failure to replace all deployed parts after a collision,
in particular, seat belt tensioners.
• An incomplete self-test prevents the HDS from
retrieving DTCs, although flash codes are available in
the Tester's SCS mode.
1. Erase the DTC memory (see page 23-38).
Does the SRS indicator go of f when the DT C
memory is erased?
YES Go to step 42.
NO Go to step 2.
2. Check the No. 2 (10A) fuse in the under-dash
fuse/relay box.
Is the f use OK ?
YES Go to step 19.
NO Go to step 3.
3. Replace the No. 2 (10A) fuse in the under-dash fuse
/relay box.
4. Turn the ignition switch ON (II), and wait for 30
seconds. Then turn the ignition switch OFF.
5. Check the No. 2 (10A) fuse in the under-dash
fuse/relay box.
Is the f use OK ?
YES The system is OK at this time.
NO Go to step 6.
6. Replace the No. 2 (10A) fuse in the under-dash fuse
/relay box.
7. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
8. Disconnect the driver's airbag 4P connector (A).
9. Disconnect the front passenger's airbag 4P
connector (A).
A
A
(cont'd)
23-353