Honda 2004 Odyssey Service Manual page 2355

SRS
DTC Troubleshooting (cont'd)
7. Unbuckle the front passenger's seat belt.
• Check resistance between the No. 1 and No. 2
terminals of the front passenger's seat belt
buckle switch 3P connector. There should be
0 1 .
• Check resistance between the No. 1 and No. 3
terminals of the same connector. There should
be an open circuit, or at least 1 M .
FRONT PASSENGER'S SEAT BELT
BUCKLE SWITCH 3P CONNECTOR
BLK
Terminal side of male terminals
BLK
Terminal side of male terminals
Is the resistance as specif ied?
YES Go to step 8.
NO Replace the front passenger's seat belt buckle
assembly, then clear the DTC.
23-290
GRY
BLU
8. Check resistance between the No. 1 terminal of the
passenger's seat wire harness (with seat heater) or
right side wire harness (without seat heater) 3P
connector and body ground. There should be
0 1 .
PASSENGER'S SEAT WIRE HARNESS 3P CONNECTOR
(WITH SEAT HEATER)
RIGHT SIDE WIRE HARNESS 3P CONNECTOR
(WITHOUT SEAT HEATER)
Wire side of female terminals
Is the resistance as specif ied?
YES Go to step 9.
NO Open in the passenger's seat wire harness
(with seat heater), right side wire harness (without
seat heater) or poor ground connection at G581. If
G581 is OK, replace the faulty harness.
9. Disconnect the negative cable from the battery.
10. Disconnect both seat belt tensioner 2P connectors
from the side wire harness (A).
BLK
A