Table of Contents
Advertisement
SRS
Symptom Troubleshooting (cont'd)
40. Remove the gauge assembly (see page 22-100),
then disconnect gauge assembly connector C (16P)
from the gauge assembly.
41. Check resistance between the No. 9 terminal of
gauge assembly connector C (16P) and the No. 5
terminal of SRS unit connector C (8P). There should
be 1
or less.
SRS UNIT CONNECTOR C (8P)
BLU
Wire side of female terminals
GAUGE ASSEMBLY CONNECTOR C (16P)
BLU
Is the resistance as specif ied?
YES
Faulty SRS indicator circuit in the gauge
assembly or poor contact at gauge assembly
connector C (16P); check the connection. If the
connection is OK, replace the gauge assembly.
NO
Go to step 47.
23-358
42. Disconnect SRS unit connector C (8P) from the SRS
unit.
C
43. Connect the HDS to the Data Link Connector (16P)
(A), and follow the Tester's prompts in the ''SCS''
menu.
C
A
Advertisement
Chapters
Table of Contents
Troubleshooting
