Honda 2004 Odyssey Service Manual page 2454

Removal ('03-04 Models)
NOTE:
• Removal of the front sensor must be performed
according to the precautions/procedures.
• Before disconnecting the front sensor 2P connector(s),
disconnect the driver's and front passenger's airbag
4P connectors, and both seat belt tensioner 2P
connector(s).
• Do not turn the ignition switch ON (II), and do not
connect the battery cable while replacing the front
sensor.
1. Remove the battery, and wait at least 3 minutes
before beginning work.
2. Disconnect the evaporative emissions canister
hose.
3. Disconnect the engine compartment wire harness
2P connector (A), and remove the two Torx bolts (B)
using a Torx T30 bit, then remove the front
sensor (C).
A
Installation ('03-04 Models)
NOTE:
• Be sure to install the harness wires so they are not
pinched or interfering with other parts.
• Do not turn the ignition switch ON (II), and do not
connect the battery cable while replacing the front
sensor.
1. Install the new front sensor with new Torx bolts (A),
then connect the engine compartment wire harness
2P connector (B) to the front sensor (C).
B
2. Reconnect the battery negative cable.
3. After installing the front sensor, confirm proper
system operation: Turn the ignition switch ON (II):
C
the SRS indicator should come on for about 6
seconds and then go off.
B
A
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
C
23-389