Honda 2004 Odyssey Service Manual page 2363

SRS
DTC Troubleshooting (cont'd)
'03-04 Models
DTC 71-2x (71-20 to 71-29, 71-2A to 71-2F):
Short to ground in the Driver's Seat Position
Sensor
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's airbag 4P connector (A)
from the cable reel.
23-298
A
5. Disconnect the driver's seat wire harness 2P
connector (with power seat) or driver's seat
position sensor 2P connector (without power seat)
from the driver's seat position sensor (A).
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC (see page 23-38).
Is DT C 7 1-2x indicated?
YES Go to step 9.
NO Faulty driver's seat position sensor; replace
the driver's seat position sensor.
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
A