Table of Contents
Advertisement
SRS
Symptom Troubleshooting (cont'd)
35. Disconnect the gauge assembly connector C (16P)
from the gauge assembly.
36. Check resistance between the No. 9 terminal of the
gauge assembly connector C (16P) and the No. 6
terminal of the SRS main harness 18P connector.
There should be 1
GAUGE ASSEMBLY CONNECTOR C (16P)
BLU
SRS MAIN HARNESS 18P CONNECTOR
Is the resistance as specif ied?
YES
Faulty SRS indicator circuit in the gauge
assembly or poor contact at the gauge assembly
connector C (16P). Check the connection. If the
connection is OK, replace the circuit board in the
gauge assembly.
NO
Open in the SRS main harness or in the
dashboard wire harness; replace the faulty
harness.
23-344
C
or less.
Wire side of
female terminals
37. Connect the HDS to the Data Link Connector (16P)
(A) and follow the Tester's prompts in the ''SCS''
menu.
A
Advertisement
Chapters
Table of Contents
Troubleshooting
