Seat Belts
Front Seat Belt Replacement
SRS components are located in this area. Review the
SRS component locations, '99-01 models (see page 23-
18), '02 model (see page 23-19), '03-04 models (see
page 23-20), and the precautions and procedures (see
page 23-21) before preforming repairs or service.
NOTE: Check the front seat belts for damage, and
replace them if necessary.
Front Seat Belt
1. Make sure you have the anti-theft code for the radio
and the navigation system, and then write down
the frequencies for the preset buttons.
2. Slide the front seat forward fully.
3. Disconnect the negative cable from the battery, and
wait at least 3 minutes before beginning work.
4. Remove the upper anchor cover (A).
A
23-4
5. For '99-02 models driver's and passenger's seat
belts and '03-04 models driver's seat belt: Pull the
lower anchor cover (A) back, and remove the lower
anchor bolt (B).
A
B
7/16-20 UNF
32 N·m (3.3 kgf·m, 24 lbf·ft)
6. For '03-04 models passenger's seat belt: Remove
the rear riser cover (see step 7 on page 20-82).
Remove the bolt (A), and release the hook (B), then
remove the lower anchor bracket (C) from the outer
weight sensor (D).
D
B
C
A
10 x 1.25 mm
47 N·m (4.8 kgf·m, 35 lbf·ft)