Passenger's Window Motor Test - Honda 2004 Odyssey Service Manual

Hide thumbs Also See for 2004 Odyssey:

Table of Contents

5. Reconnect the 4P connector to the window motor.

6. Check for voltage between the terminals.

• There should be battery voltage between the

B4 ( ) and B2 ( ) terminals when the ignition

switch ON (II).

• Connect an analog voltmeter between the B3 ( )

and B2 ( ) terminals, and run the window motor

at down or up. The voltmeter needle should

move back and forth alternately (a digital

voltmeter should show the average voltage

between 0 5 V).

• Connect an analog voltmeter between the B1 ( )

and B2 ( ) terminals, and run the window motor

at down or up. The voltmeter needle should

move back and forth alternately. (a digital

voltmeter should show the average voltage

between 0 5 V).

7. If the test is not as specified, replace the driver's

window motor.

Passenger's Window Motor Test

1. Remove the passenger's door panel (see page 20-

2. Disconnect the 2P connector from the window

Terminal side of male terminals

3. Check window motor operation by connecting

power and ground according to the table. When the

motor stops running, disconnect one lead

immediately.

4. If the motor does not run or fails to run smoothly,

Table of Contents