Honda 2004 Odyssey Service Manual page 2426

'03-04 Models
SRS indicator doesn't come on
1. Turn the ignition switch ON (II), and see if the other
indicators come on (brake system, etc.).
Do the other indicator come on?
YES Go to step 2.
NO Go to step 8.
2. Turn the ignition switch OFF, then remove the
gauge assembly (see page 22-100). Disconnect
gauge assenbly connector B (22P) and C (16P) from
the gauge assembly.
B
3. Check resistance between the No. 16 terminal of
gauge assembly connector B (22P) and body
ground. There should be 0 1.0
GAUGE ASSEMBLY CONNECTOR B (22P)
C
Is the resistance as specif ied?
YES Go to step 4.
NO Open in the BLK wire of the dashboard wire
harness or faulty body ground terminal (G503). If
the body ground terminal is OK, replace the
dashboard wire harness.
4. Check for voltage between the No. 9 terminal of
gauge assembly connector C (16P) and body
ground within the first 6 seconds after turning the
ignition switch ON (II). There should be 8.5 V or less.
GAUGE ASSEMBLY CONNECTOR C (16P)
Is the voltage as specif ied?
YES Faulty SRS indicator circuit in the gauge
assembly; replace the gauge assembly.
NO Go to step 5.
.
BLK
Wire side of female terminals
BLU
Wire side of female terminals
(cont'd)
23-361