Cisco TelePresence Administrator's Manual page 450

SIPRouteDelete
Deletes an existing SIP route, identified either by the specified index or tag.
Note: this command is intended for developer use only.
SipRouteId: <1..20>
The index of the SIP route to be deleted.
Tag: <S:0, 64>
Tag value specified by external applications to uniquely identify routes that they create.
Example: xCommand SIPRouteDelete SipRouteId: Tag: "Tag1"
SubZoneAdd
Adds and configures a new subzone.
SubZoneName(r): <S: 1, 50>
Assigns a name to this subzone.
TotalMode: <Unlimited/Limited/NoBandwidth>
Determines whether this subzone has a limit on the total bandwidth of calls being used by its endpoints at any
one time. NoBandwidth: no bandwidth available. No calls can be made to, from, or within this subzone.
Default: Unlimited.
Total: <1..100000000>
Sets the total bandwidth limit (in kbps) of this subzone (applies only if the mode is set to Limited). Default:
500000.
PerCallInterMode: <Unlimited/Limited/NoBandwidth>
Sets bandwidth limits for any one call to or from an endpoint in this subzone. NoBandwidth: no bandwidth
available. No calls can be made to or from this subzone. Default: Unlimited.
PerCallInter: <1..100000000>
Specifies the bandwidth limit (in kbps) on any one call to or from an endpoint in this subzone (applies only if
the mode is set to Limited). Default: 1920.
PerCallIntraMode: <Unlimited/Limited/NoBandwidth>
Sets bandwidth limits for any one call between two endpoints within this subzone. NoBandwidth: no
bandwidth available. No calls can be made within this subzone. Default: Unlimited.
PerCallIntra: <1..100000000>
Specifies the bandwidth limit (in kbps) for any one call between two endpoints within this subzone (applies
only if the mode is set to Limited). Default: 1920.
Example: xCommand SubZoneAdd SubZoneName: "BranchOffice" TotalMode: Limited Total: 1024
PerCallInterMode: Limited PerCallInter: 512 PerCallIntraMode: Limited PerCallIntra: 512
SubZoneDelete
Deletes a subzone.
SubZoneId(r): <1..1000>
The index of the subzone to be deleted.
Example: xCommand SubZoneDelete SubZoneId: 2
Cisco VCS Administrator Guide (X7.1)
Reference material
Page 450 of 479