Cisco TelePresence Administrator's Manual page 397

Reference material
IPProtocol: <Both/IPv4/IPv6>
Selects whether the VCS is operating in IPv4, IPv6 or dual stack mode. You must restart the system for any
changes to take effect.
Default: IPv4
Example: xConfiguration IPProtocol: IPv4
LDAP Encryption: <Off/TLS>
Sets the encryption to use for the connection to the LDAP server.
Off: no encryption is used.
TLS: TLS encryption is used.
Default: Off
Example: xConfiguration LDAP Encryption: Off
LDAP Password: <S: 0, 122>
Sets the password to use when binding to the LDAP server. The maximum plaintext length is 60 characters,
which is then encrypted.
Example: xConfiguration LDAP Password: "password123"
LDAP Server Address: <S: 0, 128>
Sets the IP address or Fully Qualified Domain Name (FQDN) of the LDAP server to use when making LDAP
queries.
Example: xConfiguration LDAP Server Address: "ldap.server.example.com"
LDAP Server Port: <1..65534>
Sets the IP port of the LDAP server to use when making LDAP queries. Typically, non-secure connections use
389 and secure connections use 636.
Default: 389
Example: xConfiguration LDAP Server Port: 389
LDAP UserDN: <S: 0, 255>
Sets the user distinguished name to use when binding to the LDAP server.
Example: xConfiguration LDAP UserDN: "user123"
Log Level: <1..4>
Controls the granularity of Event Logging. 1 is the least verbose, 4 the most.
Note: this setting is not retrospective; it will determine which events are written to the Event Log from now
onwards.
Default: 1
Example: xConfiguration Log Level: 1
Log Server Address: <S: 0, 128>
A comma-separated list of IP addresses or Fully Qualified Domain Names (FQDNs) of the remote syslog servers
to where the Event Log is written. These servers must support the BSD syslog protocol. They cannot be another
VCS.
Example: xConfiguration Log Server Address: "syslog.server.example.com"
Cisco VCS Administrator Guide (X7.1) Page 397 of 479