Configuring Subzone Membership Rules - Cisco TelePresence Administrator's Manual

Deny registrations based on IP address subnet. You can do this by creating a subzone with associated
n
membership rules based on an IP address subnet range, and then setting that subzone to deny
registrations.
Configure the Default Subzone to deny registrations. This would cause any registration requests that do
n
not match any of the subzone membership rules, and hence fall into the Default Subzone, to be denied.
Note that registration requests have to fulfill any registration restriction policy rules before any subzone
membership and subzone registration policy rules are applied.
Subzone authentication policy
To control the services available to endpoints registered to a subzone you can specify how each subzone
authenticates incoming messages and whether they are subsequently treated as authenticated,
unauthenticated or are rejected.
See the Authentication Policy configuration options
and how they are applied to zones and subzones.
Bandwidth controls
When configuring your subzones you can apply bandwidth limits to:
individual calls between two endpoints within the subzone
n
individual calls between an endpoint within the subzone and another endpoint outside of the subzone
n
the total of calls to or from endpoints within the subzone
n
See Applying bandwidth limitations to subzones
managed.

Configuring subzone membership rules

The Subzone membership rules
rules) is used to configure the rules that determine, based on the address of the device, to which
endpoint is assigned when it registers with the VCS.
The page lists all the subzone membership rules that have been configured on the VCS, and lets you create,
edit, delete, enable and disable rules. Up to 3000 subzone membership rules can be configured.
Note: if the endpoint's IP address or registration alias does not match any of the membership rules, it is
assigned to the Default Subzone.
The configurable options are:
Field Description
Rule name A descriptive name for the membership rule.
Description An optional free-form description of the rule.
Cisco VCS Administrator Guide (X7.1)
section for more information about the policy settings,
for information about how bandwidth limits are set and
page (VCS configuration > Local Zone > Subzone membership
Bandwidth control
Usage tips
The description appears as a tooltip if you
hover your mouse pointer over a rule in the
list.
subzone an
Page 208 of 479