Cisco TelePresence Administrator's Manual page 325

Video communication server
Hide thumbs Also See for TelePresence:
Table of Contents

Advertisement

Event
Description
License Limit
Licensing limits for a given feature have been reached. The Detail event parameter
Reached
specifies the facility/limits concerned. Possible values for the detail field are:
Non Traversal Call Limit Reached
n
Traversal Call Limit Reached
n
If this occurs frequently, you may want to contact your Cisco representative to purchase
more licenses.
Message
An incoming RAS message has been received.
Received
Message
An incoming RAS NSM Keepalive, H.225, H.245 or a RAS message between peers has
Received
been received.
Message
(SIP) An incoming message has been received.
Received
Message
This could be for one of two reasons:
If authentication is enabled and an endpoint has unsuccessfully attempted to send a
Rejected
n
message (such as a registration request) to the VCS. This could be either because the
endpoint has not supplied any authentication credentials, or because its credentials
do not match those expected by the VCS.
Clustering is enabled but bandwidth across the cluster has not been configured
n
identically, and the VCS has received a message relating to an unknown peer, link,
pipe, subzone or zone.
Message Sent
An outgoing RAS message has been sent.
Message Sent
An outgoing RAS NSM Keepalive, H.225, H.245 or a RAS message between peers has
been sent.
Message Sent
(SIP) An outgoing message has been sent.
Operator Call
An administrator has disconnected a call.
Disconnect
Outbound TLS
The VCS is unable to communicate with another system over TLS. The event parameters
Negotiation
provide more information.
Error
Package Install
A package, for example a language pack, has been installed.
Policy Change
A policy file has been updated.
POST request
A HTTP POST request was submitted from an unauthorized session.
failed
Provisioning
Diagnostic messages from the provisioning server. The Detail event parameter provides
additional information.
Reboot
A system reboot has been requested. The Reason event parameter provides specific
Requested
information.
Registration
A registration request has been accepted.
Accepted
Registration
A request to refresh or keep a registration alive has been accepted.
Refresh
Accepted
Cisco VCS Administrator Guide (X7.1)
Reference material
Level
1
2
3
4
1
2
3
4
1
1
2
1
1
1
1
1
3
Page 325 of 479

Advertisement

Table of Contents
loading

This manual is also suitable for:

Telepresence x7.1

Table of Contents