Restoring Default Configuration; Configuration Items Reset By Defaultvaluesset Level 3 - Cisco TelePresence Administrator's Manual

Restoring default configuration

It is possible to restore the VCS to its default configuration. This is done through the CLI using xCommand
DefaultValuesSet. This command is not available through the web interface.
The DefaultValuesSet command allows you to specify the level of configuration to restore, from 1 to 3 as
follows:
Level 1: resets most configuration items to their default value, with the exception of the Level 2 and Level 3
n
items shown in the tables below.
Level 2: resets configuration items mostly related to remote authentication (listed in Configuration items
n
reset by DefaultValuesSet level 2), plus Level 1 items to their default values.
Level 3: resets all critical configuration items (listed in Configuration items reset by DefaultValuesSet level
n
3 below) plus Level 1 and Level 2 items to their default values.
See the Command reference — xConfiguration
applicable, their default values.
Note: xCommand DefaultValuesSet Level: 3 must be used with caution, as it resets the system's
IPv4 and IPv6 addresses, meaning you will no longer be able to access the system over IP. It also deletes all
option keys including pre-installed options such as Expressway and the number of calls. It also deletes all
links configured on the VCS, including the automatically configured default links between the Default
Subzone, Traversal Subzone and Default Zone. Without these links, calls will not be able to be placed. To
restore these links, you should run the command xCommand DefaultLinksAdd after xCommand
DefaultValuesSet Level: 3. These links can also be restored manually using the web interface - see
the Default links section for more information.

Configuration items reset by DefaultValuesSet level 3

The following table lists the configuration items that are reset by xCommand DefaultValuesSet
Level: 3 and their reset values.
Configuration item
Administration HTTP Mode
Administration HTTPS Mode
Administration SSH Mode
Administration Telnet Mode
Ethernet [1..2] IP V4 Address
Ethernet [1..2] IP V4 StaticNAT Address
Ethernet [1..2] IP V4 StaticNAT Mode
Ethernet [1..2] IP V4 SubnetMask
Ethernet [1..2] IP V6 Address
Ethernet [1..2] Speed
IPProtocol
Cisco VCS Administrator Guide (X7.1)
section for a full list of all configuration items and, where
Reset value
On
On
On
Off
192.168.0.100
<blank>
Off
255.255.255.0
<blank>
Auto
IPv4
Reference material
Page 348 of 479