Restarting; Restarting Using The Web Interface - Cisco TelePresence Administrator's Manual

Restarting

The Restart page (Maintenance >
the hardware.
CAUTION: do not restart the VCS while the red ALM LED on the front of the box is on. This indicates a
hardware fault. Contact your Cisco representative.
The restart function shuts down and restarts the VCS application software, but not the operating system or
hardware.
Some configuration changes require a restart of the VCS before they take effect. A system alarm will remain
in place until the system is restarted.
Restarting causes any active calls and registrations to be terminated. For this reason, the Restart section
displays the number of current calls and registrations, so you can check these before you restart the VCS. If
you do not restart the system immediately, you should refresh this page before restarting to check the current
status of calls and registrations.

Restarting using the web interface

To restart the VCS using the web interface:
1. Go to Maintenance >
2. Check the number of calls and registrations currently in place.
3. Click Restart system.
The Restarting page appears, with an orange bar indicating progress.
After the system has successfully restarted, you are automatically taken to the
Note: to shut down and restart the VCS operating system and hardware in addition to the VCS application
software, choose the Reboot function
Cisco VCS Administrator Guide (X7.1)
Restart) allows you to restart the VCS without having physical access to
Restart. You are taken to the
(Maintenance >
Restart page.
Login
Reboot). Restarting is quicker than rebooting.
Maintenance
page.
Page 301 of 479