Cisco TelePresence Administrator's Manual page 409

Reference material
ID Title
25016 Ethernet speed
not
recommended
25017 Restart required
25018 Port conflict
25019 Verbose log
levels
configured
25020 NTP client
failure
25021 NTP server not
available
25022 Time not
synchronized
over traversal
zone
30001 Capacity
warning
30002 Capacity
warning
30003 Capacity
warning
30004 Capacity
warning
30005 Capacity
warning
30006 Restart required
30007 Capacity
warning
Cisco VCS Administrator Guide (X8.1.1)
Description
An Ethernet interface speed setting
has been negotiated to a value
other than 1000Mb/s full duplex or
100Mb/s full duplex; this may result
in packet loss over your network
HTTP service has been changed,
however a restart is required for this
to take effect
There is a port conflict between
<function> <port> and
<function> <port>
One or more modules of the
Network Log or Support Log are set
to a level of Debug or Trace
The system is unable to run the NTP
client
The system is unable to contact an
NTP server
The system time of this server is
different from that on a server on the
other side of a SIP traversal zone
The number of concurrent traversal
calls has approached the licensed
limit
The number of concurrent traversal
calls has approached the unit's
physical limit
The number of concurrent non-
traversal calls has approached the
unit's physical limit
The number of concurrent non-
traversal calls has approached the
licensed limit
TURN relays usage has
approached the unit's physical limit
The release key has been changed,
however a restart is required for this
to take effect
TURN relays usage has
approached the licensed limit
Solution
Configure Ethernet parameters
Restart the system
Review the port configuration on the
Local inbound ports and Local
outbound ports pages
Network Log and Support Log
modules should be set to a level of
Info, unless advised otherwise by
your Cisco support representative. If
diagnostic logging is in progress they
will be reset automatically when
diagnostic logging is stopped
Check NTP status information,
including any key configuration and
expiry dates
Check Time configuration and status;
check DNS configuration
Ensure that your systems have
consistent Time configuration; note
that any changes may take some
time to become effective
Contact your Cisco representative
Contact your Cisco representative
Contact your Cisco representative
Contact your Cisco representative
Contact your Cisco representative
Restart the system
Contact your Cisco representative
Alarms
Severity
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Page 409 of 507