Ucr 2008 Setup - Cisco 7975G Software Manual

UCR 2008 Setup

Field
Allow EnergyWise Overrides
UCR 2008 Setup
You configure the parameters that support UCR 2008 in Cisco Unified Communications Manager
Administration. The following table describes the parameters and indicates the procedure to change the setting.
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
160
Description
This check box determines if you will allow the EnergyWise domain
controller policy to send power level updates to the phones. The
following conditions apply:
1 If the phone is in full power save mode and the level is set to any
standby level, the phone will go to Power Save when idle and
remain in that mode until the next Cisco Unified CM scheduled
power level change or user interaction.
2 If the phone is in Power Save or at full power and the level is set
to any nonoperational level, the phone will power down when idle
and remain powered off until the switch reapplies power or the
user wakes the phone.
For example, assume the Phone Off Time is set to 22:00 (10:00 p.m.),
the value in the Phone On Time field is 06:00 (6:00 a.m.), and the
Enable Power Save Plus has one or more days selected.
• If EnergyWise directs the phone to turn off at 20:00 (8:00 p.m.),
then the directive remains in effect until the configured Phone
On Time at 6:00 a.m., assuming no phone user intervention
occurs.
• At 6 a.m., the phone will turn on and resume receiving its power
level changes from the settings in Cisco Unified Communications
Manager Administration.
• To change the power level on the phone again, EnergyWise must
reissue a new power level change command.
To disable Power Save Plus, you must uncheck the
Note
Allow EnergyWise Overrides check box. Leaving the
Allow EnergyWise Overrides checked with no days
selected in the Enable Power Save Plus field does not
disable Power Save Plus.
Features, Templates, Services, and Users