Setting Up Ucr 2008 - Cisco 6901 Administration Manual

Setting up UCR 2008

Table 5-2
Field
Enable Audible
Alert
EnergyWise Domain The EnergyWise domain that the phone is in. The maximum length is 127.
EnergyWise Secret
Allow EnergyWise
Overrides
Setting up UCR 2008
The parameters that support UCR 2008 reside in Cisco Unified Communications Manager
Administration. The following table describes the parameters and indicates the procedure to change the
setting.
Cisco Unified IP Phone 6901 and 6911 Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
5-14
EnergyWise Configuration Fields (continued)
Description
When enabled, instructs the phone to play an audible alert starting at 10
minutes before to the time specified in the Phone Off Time field.
The audible alert uses the phone ringtone, which briefly plays at specific
times during the 10-minute alerting period. The alerting ringtone plays at the
user's designated volume level. The audible alert schedule is:
• At 10 minutes before power down, play the ringtone four times
• At 7 minutes before power down, play the ringtone four times
At 4 minutes before power down, play the ringtone four times
•
At 30 seconds before power down, play the ringtone 15 times or until
•
the phone powers off
This check box applies only if the Enable Power Save Plus list box has one
or more days selected.
The security secret password that is used to communicate with the endpoints
in the EnergyWise domain. The maximum length is 127.
This check box determines whether you will allow the EnergyWise domain
controller policy to send power-level updates to the phones. The following
conditions apply:
The settings in Cisco Unified CM Administration take effect on
1.
schedule even if EnergyWise sends an override.
For example, assume the Phone Off Time is set to 22:00 (10:00 p.m.), the
value in the Phone On Time field is 06:00 (6:00 a.m.), and the Enable Power
Save Plus has one or more days selected.
• If EnergyWise directs the phone to turn off at 20:00 (8:00 p.m.), that
directive will remain in effect (assuming no phone user intervention
occurs) until the configured Phone On Time at 6:00 a.m.
At 6:00 a.m., the phone turns on and resumes receiving its power level
•
changes from the settings in Unified Communications Manager.
To change the power level on the phone again, EnergyWise must reissue
•
a new power-level change command.
To disable Power Save Plus, you must uncheck the Allow
Note
EnergyWise Overrides check box. Leaving the Allow EnergyWise
Overrides checked with no days selected in the Enable Power Save
Plus field does not disable Power Save Plus.
Chapter 5 Configuring Features, Templates, Services, and Users
OL-24582-01